Home > Articles > Sintered Stone > Dekton Small Saw Blades

DEKTON® Small Saw Blades for Angle Grinders

Manually cutting DEKTON® surfaces requires, not only a steady hand, but also a high quality blade designed for cutting very hard materials. These diamond blades are approved by Cosentino for cutting DEKTON® surfaces. The Weha R-Mesh turbo blades are designed to cut clean and fast on extremely hard materials like the following:

  • Ceramic
  • Porcelain
  • Sintered Stone
  • Ultra-Compact Surfaces

Why Use Approved Small Saw Turbo Blades?

Small Saw Blades for Angle Grinders

For many reasons, the R-Mesh turbo blades are a great choice for cutting DEKTON® using angle grinders. These small saw blades have a thin kerf and are particularly effective for making high quality cuts on hard surfaces like DEKTON®.

The R-Mesh small sized diamond blades are approved by Cosentino for use on DEKTON® and are rated highly for quality and speed. These blades not only perform well, they can used wet or dry.

The cut is extremely clean and the blade provides maximum air for cooling the blade as it cuts. These blades can be used in both wet and dry environments. The R-Mesh "DEKTON®" blade is available in the following sizes:

  • 4 Inch
  • 5 Inch
  • 6 Inch
  • 7 Inch

The blade specific rate table can be found below.

Blade Specifications

Blade Size Arbor Size Max RPM Dry Use Wet Use
4" 5/8" or 7/8" 15,300 Yes Yes
5" 5/8" or 7/8" 12,200 Yes Yes
6" 5/8" or 7/8" 10,000 Yes Yes
7" 5/8" or 7/8" 8,500 Yes Yes