Home > Bush Hammer >

Bridge Scratcher Marble
Part # 6312050 Marble Bridge Scratcher


 
Alternative Views:


Weha Price: $1,795.20

Charlotte, NC Stock Status:(Out of Stock)
Part Number: 6312050
Qty:

DESCRIPTION WHERE TO BUY
 

300 mm x 100 mm Scratching Drum for Bridge Scratcher

The 300 mm x 100 mm Scratching Drum for Bridge Scratcher is a tool in the bushhammering line of equipment designed to work in conjunction with other bushhammering texturing tools from Weha.

This 300 mm x 100 mm Scratching Drum for Bridge Scratcher is designed to be used in conjunction with the following bushammering tool lines:

  • Bridge-Scratcher

Bridge-Scratcher Bridge Saw Stone Scratching Tool

The Bridge-Scratcher is a tool designed for the fine or coarse scratching of limestone and marble.

Designed to be used on bridge saws, the scratching teeth can be turned 3 times on each of the two sides. This rotating of the scrathcing teeth allows the use of all 6 corners.

The type and width can be adjusted by changing the use of 6 scratching bits each tooth. The high quality components allow an exceptional cost/performance ratio of the tools.

Bridge-Scratcher Technical Information

Technical Specifics
Mechanical Scratching-Roller Ø 300 mm
Scratching Types Fine and Coarse
Width of Scratching Stripe 2.5 mm | 5 mm
Tool life is according to the materials to be worked on.
  • Very Easy to Use
  • Includes Mounting Accessories & Technical Instructions
  • Perfectly Even Scratching On Entire Surface
  • High Productivity With Minimal Investment
  • Size of Center Hole On Request
Description
  • Bridge-Scratcher is a tool for fine or coarse scratching of limestone, granite and marble.
    The tools are designed to be used on bridge saws.
    The scratching teeth can be turned 3 times on both sides which allows the use of all 6 corners. The type and width can be adjusted by changing the use of 6 scratching bits each tooth. The high quality components allow an exceptional cost/performance ratio of the tools.

    Bridge Scratchers have removable inserts in order to vary their position and quantity. In this way it is possible to adjust the type and width of finish. Inserts are also designed to have a long life as they can be used in all its vertices by rotating them, thus multiplying the tool life.

    The Width of the scratching stripe is from 3-9cm
    -very easy to use
    -including mounting accessories and technical instruction
    -perfectly even scratching on the whole surface
    -high productivity with minimum investment
    -size of center hole on request

Rate this product. Be the first to write a review »